ACR Electronics SmartReader Plus Instrukcja Użytkownika Pobierz pdf (Strona 33)

SmartReader Data Logger

Figure 4-2: SmartReader 4 Accessories

1.6.2 Setup

Using the Pressure Modules

1. If you are going to measure pressure, you will need a Pressure Module, a length of plastic

tubing and the appropriate fittings to tie into the system or equipment you intend to

monitor.

2. To connect the Pressure Module, plug it into the five terminals as shown in Figure 4-2.

Make sure it is properly plugged in and secured to the terminal block.

3. Use TrendReader software to enable the pressure channel. Then assign the correct

pressure equation for the model of Pressure Module you are using. If you want to switch

from one Pressure Module to another, change the equation number assigned to the

pressure channel.

Module

Range

Type

Resolution

Equation

PM-005-G

0 to 5 PSI (30 kPa)

Gauge

0.03 PSI (0.2 kPa)

PM-030-G

0 to 30 PSI (200 kPa)

Gauge

0.15 PSI (1.0 kPa)

PM-100-G

0 to 100 PSI (700 kPa)

Gauge

0.5 PSI (3.5 kPa)

PM-150-G

0 to 150 PSI (1000

kPa)

Gauge

0.5 PSI (3.5 kPa)

PM-030-A

0 to 30 PSI (200 kPa)

Absolute

0.15 PSI (1.0 kPa)

PM-100-A

0 to 100 PSI (700 kPa)

Absolute

0.5 PSI (3.5 kPa)

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 102 103

Komentarze do niniejszej Instrukcji

Brak uwag

ACR Electronics SmartReader Plus Instrukcja Użytkownika Strona 33

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nawigatory ACR Electronics SmartReader Plus