
Installation Manual 49 Y1-03-0212 Rev. E
Reaction: During the initial boot or after “factory settings” the user is
asked to enter a valid MMSI. As long as this is not done, the system
does not transmit.
Remedy: Enter a valid MMSI
5.3 Text Messages
Reaction of the System / Remedy
Reaction: the transponder unit continues operation using indirect or
semaphore synchronisation
Remedy:
Check GPS Antenna for AIS.
AIS: external DGNSS in use
Reaction: Positioning is fully operational
Remedy: no action required
AIS: external GNSS in use
Reaction: The transponder unit continues operation using the position
data from a GNSS receiver
Remedy: no action required
AIS: internal DGNSS in use
(beacon) 023
Reaction: The transponder unit uses position data from the internal
source. The internal GNSS receiver is capable of processing DGNSS
corrections.
Remedy: no action required
AIS: internal DGNSS in use
(message 17)
AIS: internal GNSS in use
Information
additional to
Alarm ID 25
Reaction: The transponder unit continues operation using the position
data from the internal GPS.
Remedy
Check the sensor and the cabling; Check if the system that delivers the
data is working; Check the baud rate settings of the sensor input
AIS: external SOG/COG in use
Reaction: COG/SOG is in full operation
Remedy: no action required
AIS: internal SOG/COG in use
Information
additional to
Alarm ID 29 or
ID 30
Reaction: The transponder unit continues operation using the data from
the internal GPS.
Remedy:
Check the sensor and the cabling; Check if the system that delivers the
data is working; Check the baud rate settings of the sensor inputs
Reaction: Heading is in full operation
Remedy: no action required
AIS: Rate of Turn Indicator in
use
Reaction: A Rate Of Turn indicator is connected and in full operation
Remedy: no action required
AIS: Other ROT source in use
Reaction: The transponder unit is operating with ROT data rather than
with TIROT data - therefore the AIS only differs between
+ 127 (turning right at 720 degrees per minute or higher) and
– 127 (turning left at 720 degrees per minute or higher)
5.4 Restarting the NAUTICAST
The NAUTICAST can be restarted during operation by pressing the keys “Shift” + “Fn” + “Del”
simultaneously. It may take up to 6 minutes to receive all information from other ships again
because of their reporting interval.
Komentarze do niniejszej Instrukcji